Pump Installation Infromation
My pump keeps losing its prime.
A: Check for: 1. Defective check or foot valve. 2. Inlet line air leakage. 3. Seal leaking. 4. Fluid supply low.
We have a new system and just installed the pump and it’s making a noisy sound, sort of like its pumping sand.
A: If the motor connections are properly set, then you need to check the actual voltage supplied at the motor. It is best to do this with the motor, and any other lights or equipment that share that circuit, running. Using a voltmeter, check the voltage across Line 1 and Line 2 leads. It should
I just installed a new unit and when I turn it on, the motor makes a funny sound and doesn’t come up to speed properly.
A: Check to make sure that the supply voltage matches the voltage the motor is set for. In other words, if your motor is wired according to 230 Volt connections, then your supply line must also be 230Volts.